KNOVA KN M-2508RC Manual page 13

ADJUSTMENTS
BEVEL STOP ADJUSTMENT (FIG. P, Q)
WARNING
To avoid injury from unexpected starting or
electrical shock, make sure the trigger is released and
remove the power cord from the power source.
90° Bevel Adjustment (Fig. P)
1. Loosen bevel lock handle (1) and tilt the cutting arm
completely to the right. Tighten the bevel lock handle.
Lower blade.
2. Place a combination square (2) on the miter table with the
ruler against the table and the heel of the square against
the saw blade.
3. If the blade is not 90° square with the miter table, loosen
the bevel lock handle, tilt the cutting head completely to
the left, loosen the locknut (4) on the bevel angle
adjustment bolt (3) and use a 13 mm wrench to adjust the
bolt (3) in or out to increase or decrease the bevel angle.
4. Tilt the cutting arm back to the right at 90° bevel and
recheck for alignment.
5. Repeat steps 1 through 4 if further adjustment is needed.
6. Tighten bevel lock handle (1) and locknut (4) when
alignment is achieved.
3
4
1
2
90° Bevel Indicator (Fig. Q)
1. When the blade is exactly 90° to the table, loosen the bevel
2. Adjust bevel indicator (6) to the "0" mark (7) on the bevel
1
2
Fig. O
45° Bevel Adjustment (Fig. Q)
1. Unlock the bevel lock handle (1) and tilt the cutting arm as
2. Using a combination square, check to see if the blade angle
3. If the blade is not at 45° to the miter table, tilt the cutting
4. Tilt the cutting arm to the left to 45° bevel and recheck
5. Repeat steps 1 through 4 until the blade is at 45° to the
6. Tighten bevel lock handle (1) and locknut (8) when
TURNING LASER GUIDE ON (FIG. R)
1. To turn laser on, press on/off rocker switch (1) to
Fig. P
2. To turn laser off, press on/off rocker switch (1) to
12
indicator screw (5) using a #2 Phillips screwdriver.
scale and retighten the screw.
1
7
6
5
far to the left as possible.
is 45° to the table.
arm to the right, loosen the locknut (8) on the bevel angle
adjustment bolt (9) and use a 13 mm wrench to adjust the
bolt (9) in or out to increase or decrease the bevel angle.
for alignment.
miter table.
alignment is achieved.
"ON" position.
"OFF" position.
Fig. Q
9
8
1
Fig. R