Updating The Control Program Version - Brother BAS-311H Service Manual

5-13. Updating the control program version

1
Place the control program that you would like to update into the folder of the SD card as specified in "5-2".
2
With the power switch turned off, insert the SD card into the SD card slot.
3
4
5
6
7
Turn off the power switch.
"WAIT" will appear in the menu
display and the value in the
tension display will
while the program version is being
updated.
2680B 2681B
While holding down the RESET, TEST and ▲ keys, turn
on the power switch.
The same "bro", "ther", "-3" (may vary depending on
specifications) and "311" as appear in the PROGRAM
No. display, menu display, section No. display and
tension display will appear. Keep holding down the keys
until you hear a beep.
3226B
"1.Mn" will appear in the PROGRAM No. display and
"*.*.**" (control program version stored on the SD card)
will appear in the menu display.
2678B
Press the △ or ▽ key to select the program to be
updated.
Control program
Mian
Motor
Panel
･
If there is no program to be updated which is stored
on the SD card, "----" ("---") will appear in the menu
display.
3227B
Press the ENTER key.
･ The buzzer will sound and updating of the program
version will start.
･
When "End" appears in the menu display, updating is
increment
complete.
･
To continue updating another program, return to step
5 and select the next program to be updated.
BAS-311H
5. USING SD CARD
PROGRAM No.
Menu display
display
[1.Mn] [*.*.**]
[2.Mt] [*.**]
[3.PL] [*.**]
3209B
2414B
48