Brother BAS-311H Service Manual page 152

11. LIST OF ERROR CODES
Feed mechanism-related errors
Code
X-feed motor home position cannot be detected.
Problem with X-feed motor or poor X home position sensor connection.
E200
Turn off the power, and then check that connectors P17, P21 and P8 on the main P.C. board are properly
connected.
X-feed motor stopped due to a problem.
E201
Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
X-feed motor stopped due to a problem during sewing.
E204
Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
X-feed motor stopped due to a problem while moving to the sewing start position.
E205
Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
X-feed motor stopped due to a problem during test feeding.
E206 Turn off the power, and then check if there are any problems in the X-feed direction.
Turn off the power, and then check that connectors P17 and P21 on the main P.C. board are properly connected.
Y-feed motor home position cannot be detected.
Problem with Y-feed motor or poor Y home position sensor connection.
E210
Turn off the power, and then check that connectors P18, P22 and P8 on the main P.C. board are properly
connected.
Y-feed motor stopped due to a problem.
E211
Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
Y-feed motor stopped due to a problem during sewing.
E214
Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
Y-feed motor stopped due to a problem while moving to the sewing start position.
E215
Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
Y-feed motor stopped due to a problem during test feeding.
E216 Turn off the power, and then check if there are any problems in the Y-feed direction.
Turn off the power, and then check that connectors P18 and P22 on the main P.C. board are properly connected.
Feed motor stopped due to a problem.
E230
Reduce the sewing speed or set memory switch No.059 = 1.
143
Cause of error and remedy
BAS-311H