Brother BAS-311H Service Manual page 112

8. ADJUSTMENT
5 <Motor-driven work clamp specifications>
Touch the bottom of the work clamp lifter plate
and check the position where it starts to lower.
For example, if the offset
value is -2.
<Pneumatic work clamp specifications>
Index mark
103
For example, if the offset
value is -2.
1. Press the ▲ or ▼ key to change the offset value (-999 to
999) so that the work clamp lifter plate (1) moves to the
position where it starts to lower.
The offset value in the menu display will flash, and "JoG"
will illuminate in the PROGRAM No. display.
2. Press the ▲ key once to reduce the offset value by 1.
･
The work clamp lifter plate (1) will move in conjunction with
the setting value.
1.
Remove the rear cover, align the index marks of the work
clamp cam gear (2) and the work clamp driving gear (3) to
the center line, and then press the
the offset value (-999 – 999).
The offset value in the menu display will flash, and "JoG"
will illuminate in the PROGRAM No. display.
2. Press the ▲ key once to reduce the offset value by 1.
･
The work clamp driving gear (3) will move in conjunction
with the setting value.
BAS-311H
5206Q 2800B 2801B 2899B
or key to change
5207Q 2800B 2801B 2899B