Eu Declaration Of Conformity; Explication Of Warning Symbols; Safety Instructions - IKA MATRIX DELTA PLUS Manual

Source language: German

EU Declaration of conformity

We declare under our sole responsibility that this product corresponds to the directives 2014/35/EU,
2006/42/EC, 2014/30/EU and 2011/65/EU and conforms with the following standards or normative
documents: EN 61010-1, EN 61010-2-010, EN 61326-1, EN 60529 and EN ISO 12100�
A copy of the complete EU Declaration of conformity can be requested at sales@ika�com�

Explication of warning symbols

/// Warning symbols
Danger!
Indicates an (extremely) hazardous situation, which, if not avoided,
will result in death, serious injury�
Warning!
Indicates a hazardous situation, which, if not avoided, can result in
death, serious injury�
Caution!
Indicates a potentially hazardous situation, which, if not avoided, can
result in injury�
Notice!
Indicates practices which, if not avoided, can result in equipment damage�
!
Caution!
Indicates a hazardous situation that cause from a hot surface!
Caution!
Indicates crushing risk to fingers / hands�
/// General Symbols
A–––
Position number
Correct / Result!
Shows the correct execution or the result of an action step�
Wrong!
Shows the incorrect execution of an action step�
Note!
Displays action steps that require particular attention to detail�
Closed lock!
Indicates the status of "locked"�
Open lock!
Indicates the status of "Unlocked"�
6

Safety instructions

/// General information
› Read the operating instructions completely before starting up and follow the safety
instructions.
› Keep the operating instructions in a place where it can be accessed by everyone�
› Ensure that only trained staff work with the device�
› Follow the safety instructions, guidelines, occupational health and safety and accident
prevention regulations�
› The device must only be used in a technically perfect condition�
Caution!
› Wear your personal protective equipment in accordance with the hazard category of the
medium to be processed, there is a risk of:
- splashing of liquids
- release of toxic or combustible gases
- body parts, hair, clothing and jewellery getting caught�
Notice!
!
› Pay attention to the marked sites in Fig� 1 and Fig� 2�
/// Device setup
Caution!
› The power switch of the device must be accessed immediately, directly and without risk at
any time� If access to the power switch cannot be ensured, an additional emergency stop
switch that can be easily accessed must be installed in the work area�
› Ensure that your hands / fingers do not get crushed when setting down the device�
Notice!
!
› Set up the device in a spacious area on an even, stable, clean, non-slip, dry and fireproof surface�
› Make sure that the ventilation slots are not blocked at back of the device�
› Observe the minimum distances:
- between devices min� 100 mm
- between device and wall min� 100 mm�
Min. 100 mm
Min. 100 mm Min. 100 mm
!
7