Bay Tek Games Prize Hub Modular Service Manual page 9

QUICK SET UP GUIDE
Feed the loose connector ends of the red, black and
white power cables (connected to the control board
of each hub) through the large holes near the floor
of the cabinets. Link to the adjoining hubs, going
from the outside hubs toward the Main hub. There
are two connector ends on each cable; the outer-
most cabinets will only use one.
The power cables are numbered as follows:
Spindle Hub: CE1820
Capsule Hub: CE1813
Locker Hub: CE1810
Plug the two final ends into the CE1805 cable inside
the Main hub.
See diagram below...
LOCKER SPINDLE MAIN CAPSULE
CE1805
CE1810 CE1820 CE1813
9