Advertisement
Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Installation Instructions (Kit # 9002-7601)
CAUTION:
Once correct wires have been identified, turn Ignition key OFF and DO NOT turn key back ON until the install has been completed (Step 13).
4: Splice the red and black Power Harness leads into the corresponding vehicle wires (Recommended: Soldering or T-taps as optional connection
method; eyelet for the ground connection.)
5: I nsert connector end of the Camera Harness through the hole you drilled.
6: Route Camera Harness . Continue routing harness to side of vehicle that supplies power and forward.
7: C onnect Camera Harness to supplied Chassis Harness .
8: R oute Chassis Harness .
9: Secure Camera Harness to existing vehicle wiring . (Recommended: Wire Ties or Electrical Tape.)
10: Connect Chassis Harness red wire to reverse and black to clean chassis ground.
11: Install aftermarket display/ Navigation display a s per instructions ( if required) .
12: Connect Power Harness RCA to "Camera IN" on aftermarket display/ Navigation display.
13: Test the system.
14: Adjust Camera angle (if necessary). Loosen the camera screw using supplied Allen wrench to aim. Tighten screw at desired adjustment.
15: Reassemble vehicle . Follow disassembly steps in reverse order, taking care not to bind harness.
NOTE : This camera has grid lines or non grid lines and mirror image or non mirror image options:
Grid line options: Default setting is to display grid lines. To remove the grid line display, connect the two green wires near the end of the camera harness.
Display options: Default setting is mirror image display for rearward facing camera (rear view) installation. To change to non mirror image for forward facing
camera (front view) connect the two white wires near the end of the camera harness.
9002-7601 Instructions 6-10-19
Page 5 of 5
KB
Advertisement
