Advertisement
Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Green Wire Connected
No Park Lines
Step 1: Select and Install Camera Bracket
Determine which of the two supplied camera mounting
methods you prefer.
License Plate Bracket
Alternate Camera Mount Bracket
Place camera in desired position to confirm fitment (Note:
Some states prohibit items blocking the license plate; check
local authorities to confirm legal status for your application).
If using L icense Plate Bracket , remove license plate.
Reattach license plate securing bracket behind.
If using A lternate Camera Mount Bracket , remove
camera from License Plate Bracket using supplied Allen
wrench. Attach camera to the Alternate Camera Mount
bracket and apply supplied self-adhesive foam to mount.
9002-7601 Instructions 6-10-19
Installation Instructions (Kit # 9002-7601)
Green Wire Cut
Park Lines
Page 2 of 5
White Wire Connected
Front Camera
Use the Template included in the Installation Instruction
Overview to position the Alternate Camera Mount on vehicle
Clean vehicle surface to which mount is to be attached
and affix with self-adhesive foam. RECOMMENDED:
Permanent attachment using screws.
Step 2: Measure, mark, and drill ¼" hole for camera
harness. N OTE: I f your vehicle has a liftgate panel/trunk
trim cover, it must be removed.
Step 3: Determine location of vehicle power and
ground. U sing a vehicle specific service guide and/or specific
wiring diagram and a multi-meter or computer-safe test light,
locate which side of the vehicle contains reverse and Ground
wires (Chart A).
White Wire Cut
Rear Camera
KB
Advertisement
