Honda EG3600CX Manual page 201

82Z30000.book 8 ページ ２０１０年６月２５日 金曜日 午後５時５０分
CYLINDER BLOCK
PISTON SKIRT O.D.
Measure and record the piston O.D. at a point 10 mm
(0.4 in) from the bottom of the skirt and 90 degrees to
the piston pin bore.
EG3600CX/EG4000CX:
STANDARD:
SERVICE LIMIT:
EG4500CX/EG5000CX:
STANDARD:
SERVICE LIMIT:
EG5500CX/EG6500CX/EG5500CXS/EG6500CXS:
STANDARD:
SERVICE LIMIT:
If the measurement is less than the service limit,
replace the piston (page 14-6).
Inspect the cylinder sleeve I.D. (page 14-7) with this
inspection.
PISTON-TO-CYLINDER CLEARANCE
Subtract the piston skirt O.D. from the cylinder sleeve
I.D. to obtain the piston-to-cylinder clearance.
STANDARD:
SERVICE LIMIT:
If the calculated clearance is more than the service
limit, replace the piston (page 14-6) and recheck the
clearance.
If the clearance is still more than the service limit with
the new piston, replace the cylinder barrel (page 14-4).
PISTON PIN BORE I.D.
Measure and record the piston pin bore I.D. of the
piston.
EG3600CX/EG4000CX:
STANDARD:
SERVICE LIMIT:
Except EG3600CX/EG4000CX:
STANDARD:
SERVICE LIMIT:
If the measurement is less than the service limit,
replace the piston (page 14-6).
Inspect the piston pin O.D. (page 14-9) with this
inspection.
14-8
76.965 – 76.985 mm
(3.0301 – 3.0309 in)
76.85 mm (3.026 in)
81.965 – 81.985 mm
(3.2270 – 3.2277 in)
81.85 mm (3.222 in)
87.965 – 87.985 mm
(3.4632 – 3.4640 in)
87.85 mm (3.459 in)
0.015 – 0.052 mm
(0.0006 – 0.0020 in)
0.12 mm (0.005 in)
18.002 – 18.008 mm
(0.7087 – 0.7090 in)
18.042 mm (0.7103 in)
20.002 – 20.008 mm
(0.7875 – 0.7877 in)
20.042 mm (0.7891 in)
90°
10 mm
(0.4 in)