Honda EG3600CX Manual page 140

82Z30000.book 7 ページ ２０１０年６月２５日 金曜日 午後５時５０分
OIL ALERT UNIT INSPECTION
Remove the oil alert unit (page 8-5).
Measure the resistance between the wire connector
terminals of the oil alert unit and oil alert unit body.
(–)
probe (Black)
• Use a tester that is equivalent to or higher than
• Use a R x 1 scale of a commercially available
OIL LEVEL SWITCH INSPECTION
SYSTEM INSPECTION
Remove the harness clip base bolts (page 8-5).
Disconnect the oil level switch wire connector
Check continuity between the oil level switch wire
connector
engine ground (2).
There should be no continuity when the engine is full of
oil.
If the correct continuity is not obtained, inspect the oil
level switch.
(+) probe
(Black) (Yellow)
– 500 Ω – 10 kΩ
(Yellow)
Ground
(1)
performance specified:
Internal resistance: 20 Ω VDC, 9 Ω/VAC
multimeter, and meter shows current flow from
negative (–) to positive (+). The meter shows current
flowing one way and not the other the diode is good.
switch side (Yellow) terminal and
Ground
(1)
–
–
.
(2)
IGNITION SYSTEM
(1)
8-7