Honda EG3600CX Manual page 184

82Z30000.book 3 ページ ２０１０年６月２５日 金曜日 午後５時５０分
CYLINDER HEAD REMOVAL/INSTALLATION
Set the piston at top dead center of the cylinder compression stroke (page 3-7).
Remove the following parts:
– Carburetor/carburetor insulator (page 5-6)
– Control base (page 6-2)
– Muffler (page 11-2)
Installation is in the reverse order of removal.
Check the valve clearance, and if necessary, adjust the clearance (page 3-7).
HEAD COVER PACKING
INSTALLATION:
Note the installation direction.
HEAD COVER
HEAD COVER
HEAD COVER
BOLT
HEAD COVER
WASHER
CYLINDER HEAD
INSTALLATION:
Before installing the cylinder head, remove
any carbon deposits from the combustion
chamber, and inspect the valve seat.
After installing the cylinder head, measure
the cylinder compression.
HEAD
COVER
PACKING
BOLT
(Apply to the threads and
(10 x 80 mm) (4)
seating surface)
REMOVAL/INSTALLATION:
Loosen and tighten the four bolts in a crisscross pattern in 2 – 3 steps.
TORQUE: 35 N·m (3.6 kgf·m, 26 lbf·ft)
CYLINDER HEAD
DOWEL PIN (12 x 20 mm) (2)
CYLINDER HEAD GASKET
BREATHER
TUBE
13-3