Honda EG3600CX Manual page 181

82Z30000.book 2 ページ ２０１０年６月２５日 金曜日 午後５時５０分
ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL/INSTALLATION
Remove the following:
– Muffler (page 11-2)
– Fuel tank (page 5-4)
– Recoil starter grip (page 9-4)
NUT (10 mm) (4)
INSTALLATION:
Tighten the nut to the specified torque while holding
the upper bracket of rubber mount by suitable tool.
TORQUE:
34 N·m (3.5 kgf·m, 25 lbf·ft)
RUBBER MOUNT (OPPOSITE MUFFLER SIDE) (2)
INSTALLATION:
• Insert alignment tabs into the holes.
• Make sure the rubber is not chipped hard or worn.
• Note the installation direction.
ENGINE
BOLT
(10 x 40 mm)
(2)
STOPPER BRACKET
NUT (10 mm) (2)
12-2
RUBBER MOUNT (MUFFLER SIDE) (2)
INSTALLATION:
• Insert alignment tabs into the holes.
• Make sure the rubber is not chipped hard or worn.
• Note the installation direction.
NUT (8 mm) (4)
24 N·m (2.4 kgf·m, 18 lbf·ft)
STOPPER RUBBER (2)