Honda EG3600CX Manual page 102

82Z30000.book 5 ページ ２０１０年６月２５日 金曜日 午後５時５０分
FUEL VALVE REMOVAL/
INSTALLATION
Disconnect the fuel tank tube (1) and fuel tube (2).
Remove the fuel valve (3) from the fuel valve stay (4).
Install and tighten the fuel valve nut while holding the
nut part (5) of fuel valve stay by a tool.
TORQUE:
Connect the fuel tank tube and fuel tube.
• Be sure the tube clips (6) are installed correctly.
AIR CLEANER REMOVAL/
INSTALLATION
AIR CLEANER CASE
BOLT (5 x 18 mm) (4)
5.4 N·m (0.55 kgf·m, 4.0 lbf·ft)
AIR CLEANER COVER
AIR CLEANER ELEMENT
13.5 N·m (1.4 kgf·m, 10 lbf·ft)
AIR CLEANER CASE SEAL
NUT (6 mm) (2)
8.5 N·m (0.87 kgf·m, 6.3 lbf·ft)
BOLT (6 x 32 mm)
AIR CLEANER COVER SEAL
Replace if necessary.
(2)
(6)
AIR CLEANER BASE
CARBURETOR SPACER
INSTALLATION:
Before installing, check for damage.
Note the installation direction.
Viewed from air cleaner side
FUEL SYSTEM
(5)
(4)
(1)
(6)
(3)
BREATHER TUBE
5-5