HMS Networks Anybus Wireless Bolt CAN User Manual page 15

Configuration
Default Easy Config Mode
Fig. 8 The default mode is Easy Config Mode 4
By default Wireless Bolt and Bridge starts in Easy Config Mode 4.
Configuration of Wireless Bolt and Bridge Clients can be performed wirelessly, via a PC
connected to the Wireless Bolt or Bridge Access Point.
After factory reset, Wireless Bolt will by default start in Easy Config Mode 4, if there is no
Ethernet connection.
When connection is established via the wireless interface, the Wireless Bolt or Bridge Client does
not need to be connected with an Ethernet cable during configuration.
® ™
Anybus Wireless Bolt CAN User Manual
13 (46)
scm-1202-175 1.1 en-US