HMS Networks Anybus Wireless Bolt CAN User Manual page 38

Configuration
5.3.2 Activate Easy Config
1. Navigate to the web interface of Access Point unit 2.
The default address to Access Point unit 2 is 192.168.0.99.
2. Activate one of the following Easy Config Modes:
– Easy Config Mode 1 for Bluetooth PANU-PANU. Used for setting up point-to-point
communication.
– Easy Config Mode 5 for WLAN
– Easy Config Mode 6 for Bluetooth
3. Connect Client unit 1 to power.
→ Client unit 1 starts up in Easy Config Mode 4 and is open for automatic configuration during
120 seconds.
→ Access Point unit 2 will discover and configure Client unit 1 as a Client and configure itself as
an Access Point.
→ Client unit 1 will be assigned the first free IP address in the same Ethernet subnet as Access
Point unit 2.
The default address to the first Client unit is 192.168.0.100.
→ If no connection is established during Easy Config Mode:
– Ensure that Client unit 1 is disconnected from Ethernet.
– Disconnect Client unit 1 from power and repeat Activate Easy Config step 5 and 6.
5.3.3 Adding More Wireless Bolt CAN Clients
When using Easy Config Mode 1, continue with CAN Configuration.
When using Easy Config Mode 5 or Easy Config Mode 6, up to 6 additional Wireless Bolt CAN
Clients can be added to the CAN bridge.
1. To add more Client units, repeat Connecting the Devices step 1 and the Activate Easy Config
steps.
→ Each new Client unit will be assigned the next free IP address in the current Ethernet subnet.
® ™
Anybus Wireless Bolt CAN User Manual
36 (46)
scm-1202-175 1.1 en-US