Firmware Loader Page - Extron electronics DVS 605 Series User Manual

RS-232 Settings
To configure the RS-232 settings (see figure 89,
1. From the Baud Rate drop-down menu, select the appropriate baud rate.
2.
From the Stop Bits drop-down menu, select the number of bits used to indicate a
byte.
3. From the Bits drop-down menu, select the number of data bits to transmit.
4. From the Parity drop-down menu, select the parity checking type.
5. Click Save.
Ethernet Settings
NOTE: The default setting is DHCP set to OFF, IP address = 192.168.254.254.
To configure the Ethernet settings for use with DHCP (
In the Ethernet Settings section, select the Use DHCP checkbox.
1.
2. Click Save (
IT administrator for more information.
To configure the Ethernet settings with a static IP address (
1.
In the IP Address field, enter an IP address for the device.
2. In the Subnet Mask field, enter the subnet mask for the device.
3. In the Default Gateway field, enter the default gateway to be used.
4. Click Save (

Firmware Loader Page

This page allows the user to update the device firmware.
Click this button
Figure 90.
). An IP address is automatically assigned to the device. Contact your
3
).
3
to open the page.
Firmware Loader Page
on the previous page):
1
):
2
):
2
1
2
DVS 605 • Using the Default Web Pages 118