Chapter 2 Install Your Product; Plug In Power; Connection - RGBlink IC2 User Manual

Chapter 2 Install Your Product

2.1 Plug in Power

There are two ways of power supply:
1. Connect 12V power adapter and power cable to the wall socket,as shown in the picture below;
2. Connect IC2 to PoE Switcher via CAT6 cable,as shown in the picture below;

2.2 Connection

Connection mode as shown in the picture below:
1. As TX,connect HDMI input source to IC2 TX HDMI IN port.
2. As RX,connect monitor to IC2 RX HDMI OUT port.
3. Workstation:connect mouse and keyboard to RX USB port.
4. Connect all the IC2 device to the same Gigabit Switch via CAT6 cable.
5. Connect control computer to Gigabit Switch via CAT6 cable.
Note:Only the USB port with the host icon can achieve KVM control;The Gigabit Switch is essential and
make sure that all the IC2 and control computer shall in the same network segment.
IC2 User Manual 11