Using Smpte Timecode; The Setup Patch Submenu; The Setup Ctrl Submenu - Jands Event 4 User Manual

JANDS – Event 4 Version 5 Users Manual
previous section and turn Midi on in the Setup Midi submenu. Then a MTC Stack
must be assigned to one of the Assign masters.
Press Setup and open the Midi submenu.
Midi
Move the cursor to the MTC field and press + (On) to open the Midi Timecode
submenu.
Any number of Assign masters can be set to 'listen' for Midi note messages.
Source
Playback Sets MTC playback Off or On. A MTC Stack must be on one of the
MTC Time Sets the internal time code start time and when running shows the
17.1.15

Using SMPTE TimeCode

The Event4 can be triggered by SMPTE timecode using the procedure detailed in the
previous section. However a SMPTE to Midi timecode convertor is required.
Note:
generator. For SMPTE to MTC conversion the frame rate is detected and set
automatically.
http://www.midiman.net/products/midiman/syncman.php

17.2 The Setup Patch Submenu

Press Setup and open the Ptch submenu to set begin patching. Patching is detailed
in Section 5

17.3 The Setup Ctrl Submenu

Press Setup and open the Ctrl submenu to set the operation of a number of console
controls.
Page 66
Midi Prog/Note
Off +to|
The MIDI field must be turned ON for MIDI to be used. The MIDI
interface can be configured (using the other menu fields) to suit your
requirements and then turned On and Off as required.
MTC Source Playback
Internal Stopped
Sets the Event to either use it's own Internal timecode or an
External source. Normally an external source such as a home studio
recorder would be used as a timecode source. The Internal source is
mainly used for testing purposes.
Assign masters before this field can be turned on.
Timecode.
The Midiman Syncman Plus is an SMPTE to MTC converter and MTC
Revision 5.0.0.5
MTC
+to|
MTC Time
00:00:00:00
25/11/02