Patching Scrollers; Clearing The Patch - Jands Event 4 User Manual

JANDS – Event 4 Version 5 Users Manual

5.1.4 Patching Scrollers

Press Setup, open the Patch submenu and open the Scrollers, submenu. Up to
80 Scrollers can be patched to the Event 4.
Scroller Sets the first Scroller number for the fixture type to be patched. Scroller
Thru
Type
Part
Dx
DMX
Thru
Press Record to save Patch changes. To discard changes press Exit.
5.2

Clearing the Patch

Press the Clear button to open the Clear menu.
Move the cursor to the PTCH (Patch) field.
Press the + (On) button to open the Clear Patch menu.
Move the cursor to the Type field and set the type of Patch which will be formed after
the old one is cleared. The two options are:
1 to 1 - Patches Fader 1 to DMX Output 1 Channel 1, Fader 2 to DMX Output 1
Channel 2 and so on to the maximum number of desk channels.
Null – Doesn't patch any Fader to any DMX channel.
Move the cursor to the LVLS (Levels) field.
Set the default level for each DMX channel in the Patch.
Page 18
numbers correspond to the Scroller palette selector buttons on the front
panel.
Sets the last Scroller of the group being patched.
Normally set to Scroller. The field can be left blank to unpatch scrollers.
The HTP (Intensity) and LTP (colour) channels must be patched
separately. Set the HTP channel for each scroller to the dimmer channel
that controls the lamp behind the scroller.
SCRL Thru Type
1 1 Scroller LTP
SCRL Thru Type
1 1 Scroller HTP
Select which DMX output (1 or 2) to patch the scroller(s). The HTP and
LTP channels do not have to be on the same DMX output.
Sets the start DMX address of this Scroller or group of Scrollers. The
start channel for LTP and HTP channels must be set separately.
Displays the end DMX address (generated by the console, this field
cannot be edited).
Revision 5.0.0.5
Part Dx-DMX Thru Opts
1- 61 61 +to|
Part Dx-DMX Thru Opts
1- 1 1 +to|
1
25/11/02