The Edit Memory Controls; Editing With The Programmer Controls; Editing With The Preset Faders; Editing Fader Channels With The Keypad - Jands Event 4 User Manual

Save As
10.5.4

The Edit Memory Controls

10.5.4.1

Editing with the Programmer Controls

The Record field in the Edit Memory menu should be set to All or Prog when
editing Fader levels. Otherwise any changes will not be saved.
The programmer is always 'Live' when editing. However it is possible to pull down the
Fixture Master to turn off the Intensity of any fixtures being adjusted in the
programmer.
10.5.4.2

Editing with the Preset Faders

The Record field in the Edit Memory menu should be set to All or Preset when editing
Fader levels. Otherwise any changes will not be saved.
Note:
channels. Editing can be carried out 'blind', that is, without the changes being seen on
stage, or 'live' if that Memory is currently being output to the stage (by one of the
Assign Masters).
Whenever the EDIT MEMORY menu is opened the Preset faders are disabled from
outputting to the stage. However, they can be used to set levels for the item being
edited.
10.5.4.3

Editing Fader channels with the Keypad

The Record field in the Edit Memory menu should be set to All or Preset when
editing Numeric keypad, otherwise any changes will not be saved.
See section 8.2 for details on using the keypad.

10.6 Clearing Memories

Memories and Chases can be cleared to free console Memory or to prevent further
use.
25/11/02
Allows the item being edited to be saved as a new Memory. This
provides a quick way to create new looks from existing programming.
1. Use the Programmer to adjust Intensity, Position, Colour and Beam settings.
Editing with the Programmer controls is the same as when recording.
2. Press Record button.
1. Use the Preset 1 (top preset) faders to set new levels. To edit a channel this
way, the fader first has to be moved to match the existing level and then
moved to the new level. The simplest way to do this is to move the fader from
zero to full and then to the new level.
2. Press the Record button.
A Memory can be edited to change the level of a channel or groups of
1. Use the Fader, And, At & Thru buttons to adjust Intensity levels.
2. Press Record button.
Draft
Software Version 5.0
Page 41