Master Controls; Pr1 And Pr2 Faders; Add / Solo Master Switch; Preset1 / Preset2 Master Switch - Jands Event 4 User Manual

JANDS – Event 4 Version 5 Users Manual

7 Master Controls

7.1

Pr1 and Pr2 Faders

The Pr1 Master fader scales the overall level of the top row of Preset faders, likewise
the Pr2 Master fader scales the overall level of the bottom row of Preset faders. By
moving the Pr1 fader up while moving the Pr2 fader down it is possible to crossfade
between the settings on the two rows of channel Preset faders.
7.2

Add / Solo Master Switch

The Flash buttons can be set to operate in three different ways or turned off
completely. To change the operation of the Flash buttons press the Add / Solo switch.
With each press of the button, the LED within the switch changes to indicate which
mode has been selected.
Add: Indicated by the green LED. Pressing a Flash button causes that output to flash
instantly to the level set by the Add/Solo Master fader.
Add Latch: Indicated by the Green LED Flashing. The Flash buttons push-on and
push-off instead of flashing. When a Flash button is latched on, the channel LED will
flash synchronously with the Add/Solo switch LED. If Add Latch is disabled while
some channels are latched, the channels will unlatch but will not become latched again
if Add Latch is subsequently enabled.
Solo: Indicated by the Red LED. Pressing a Flash button causes that output to flash
instantly to the level set by the Add/Solo Master fader, while at the same time turning
off all other desk intensity.
Disabled: Indicated by neither LED being on. Pressing a channel Flash button has NO
effect.
7.3

Preset1 / Preset2 Master Switch

When in single preset mode the flash buttons can be used to control the lower or upper
channels. Pressing the P1/P2 button toggles the function.
Lower: indicated by the green LED.
Upper: Indicated by the red LED.
7.4

DBO Switch

This button performs two functions:
Blackout: When the button is pressed the intensity output of the console is blacked
out. The button can be set to:
Momentary - the console is Blacked Out only while the DBO button is held down.
Latching - the console is Blacked Out by pressing the DBO button. Output is restored
when the DBO button is pressed again.
Inhibit: To prevent a channel from appearing in any output, hold a channel Flash
button down and press the DBO button.
Page 20 Revision 5.0.0.5 25/11/02