Storage; Lubrication - UNIA FENIX G Operating Manual

4.2.

Storage

If the machine will not be used for a longer period of time:
•
Store the machine in a roofed area, if possible.
•
The machine must be stored in its resting position. All working units should be lowered to the ground
to ensure good stability.
•
Disconnect the electrical controls and place them in a dry place.
•
Secure the machine against rust. Spray the oil that is readily biodegradable, e.g. rapeseed oil.
•
Remove the wheels
•
Protect piston rods of hydraulic cylinders against rust.
•
Storage should be out of the reach of unauthorized persons, especially children and pets.
Do not spray oil or any anti-corrosion agent on plastic or rubber parts, as they may become brittle and break.
4.3.

Lubrication

Machine lubrication:
The machine must be lubricated regularly and after each high-pressure cleaning, and after the period
specified by the manufacturer in the lubrication chart. This will keep the machine operational and reduce
preparation costs as well as reduce downtime.
Lubrication
intervals
Every 50 hours
of work
Every 50 hours
of work
Every 100 hours
of work
Once a season
Eevery 50 hours
Once a season
FENIX G Operating manual
Fig. 19 Lubrication diagram
Place of lubrication
1- Pre-emergence marker disc hubs
2- Cylinder heads
3- Marker pin.
4- Chain of the gear.
5- Bearing of rear shafts
6- Coulter adjustment screws
- page 29 -
Number of Grease
lubrication points type
2 ŁT-42
4 ŁT-42
4 ŁT-42
2 ŁT-42
2 ŁT-42
2 ŁT-42