Table of Contents
Advertisement
3.3. Operation and Setting of Metering Unit.
Ensure that the dispenser is clean before each use. This will affect its good operation.
Each container has a volumetric type separation unit consisting of wheels with distribution channels. You can
change the dosage by changing the volume of the seed wheel, by screening it. The sliding gear on the unit (red)
allows you to reduce its speed by half.
CAUTION!
The screen of the unit (Fig. 6) is used to equalize the pressure when sowing large doses
(close the screen when over 350 kg/h). For the remaining doses, the screen should be in the
open position.
3.3.1. Calibration test on the FENIX G seed drill.
Three types of controllers are used to operate the seed drill.
- Standard controller for reading basic parameters.
- Pilot seed (additional option)
- Drill Control (in the version with a mechanical drive).
Calibration in the version with electric drive.
After performing the necessary settings (see sowing chart):
Calibration in the version with electric drive.
1. Depending on the type of seeds and the desired dose
Set the seed wheel to the correct position on the scale. (information in the sowing chart)
FENIX G Operating manual
Fig. 6 Metering unit
- page 19 -
Screen of the unit
Advertisement
Table of Contents
