Table of Contents
Advertisement
4.5. Lighting Installation.
1 - left position lamp (not available in mounted machines), 2 - right position lamp (not available in
mounted machines), 3 - rear right lamp unit, 4 - left rear lamp unit 5 - connection cable
The electrical installation in the FENIX seed drill is of fixed type, provided with two rear lamp units. A connection
cable (5) is used to connect the installation with the tractor installation. The installation diagram is connected
according to Fig.20. Before leaving for highways, check the correctness of the electrical installation every time.
5.
Disassembly and decommissioning.
The user of the machine, in accordance with the provisions on environmental protection, is obliged to
conduct proper waste management agreed with the relevant local self-government authorities.
As part of these activities, at the time of replacement and scrapping of parts and assemblies or
liquidation of the entire device, the user should:
•
parts that are still suitable for further use can be preserved and stored in the warehouse,
•
the scrap metal parts must be handed over to the scrap collection point,
•
components made of cardboard, paper, plastics, rubber, etc., should be transferred to points dealing
with the purchase of recyclable materials,
•
used oil from meshing devices should be handed over to companies managing the collection of used oils
and lubricants; otherwise, follow local regulations regarding waste management for environmental
protection.
6.
Manufacturer's Liability.
The manufacturer shall not be liable, if the machine is operated contrary to the law, safety regulations or
recommendations of this manual. Because, during operation of the machine, situations not provided for in this
manual may occur, the user should always follow the general safety rules.
The manufacturer's responsibility shall be excluded in the event of arbitrary use on the machine spare parts or
parts other than genuine or approved by the manufacturer.
The manufacturer shall not be liable for indirect damages, including damage to other machines or devices.
The manufacturer shall not be responsible for the wrong selection of seeds, their type or quantity. If your own
experience in this area proves to be insufficient, you should ask a specialist for help.
The manufacturer's liability shall not cover improper (or departing from expected) work results. In any case, the
user must control and supervise the cultivation and sowing to ensure that the sown dose is correct under all
operating conditions. The user should also constantly check the correctness of sowing.
FENIX G Operating manual
Fig. 20 Lighting Installation diagram
- page 32 -
Advertisement
Table of Contents
