Table of Contents
Advertisement
1.
2.
Regularly check the tightness of the bolt nuts and tighten them if necessary!
3.
Ensure safety when carrying out maintenance work with the machine lifted by using appropriate
supports!
4.
Use suitable tools and gloves when changing working tools!
5.
Oils, grease and filters must be disposed of in accordance with the regulations!
6.
Always cut off the power supply before starting work on the electrical system!
7.
If the safety devices are worn out, check and replace them as soon as possible!
8.
Spare parts must at least meet the technical requirements specified by the manufacturer! This condition
is met by original parts!
9.
When carrying out electric arc welding on the tractor and attached devices, disconnect the cables on the
generator and on the battery!
VIII. RESTRICTIONS ON TRAVELING ON PUBLIC ROADS
•
Never exceed the speed limits during transport:
o on roads with a smooth surface (asphalt) up to 25 km / h,
o on dirt or cobblestone roads 6 ÷ 10 km / h,
o on rough roads no more than 5 km / h,
follow the traffic regulations in your country!!
•
Driving speed must be adjusted to the road conditions so that the unit does not jump on the tractor's
suspension system and there is no excessive load on the machine frame and the tractor's suspension
system!
•
Pay special attention when passing and overtaking other vehicles and on curves (device rigidly
connected to the tractor)!
•
The machine, as a part of the vehicle protruding beyond the rear side contour of the tractor covering
its rear lights, poses a threat to other vehicles traveling on the road!
•
When transporting the machine on public roads, it is mandatory to use lighting devices, a warning
sign and side reflectors.
The unit is connected to the tractor by means of links and the central bolt of the tractor.
It is forbidden to exceed the permitted speed of 25 km/h.
If it is necessary to leave the unit on a sloping terrain, it is absolutely necessary to secure the unit with the brake
and secure the road wheels by placing wedges.
The machine prepared for work exceeds the permitted transport width of 3 m. In order to adapt the
machine for transport on public roads, perform the following steps:
1. Retract the leg that drives the sowing system (only in versions with a mechanical drive).
To retract the drive wheel:
a) Remove the wheel securing cotter pins [2].
b) Retract the leg [1].
c) Secure the wheel with cotter pins [2]
FENIX G Operating manual
Maintenance, cleaning and troubleshooting work should be
performed basically with the drive turned off, the engine at a
standstill and the key removed from the tractor ignition
switch.
- page 11 -
Advertisement
Table of Contents
