Table of Contents
Advertisement
15. When replacing the knives, pay attention not to replace the right knives with left knives and vice versa.
The knife blade should point in the direction of rotation. After installing the knives, check by hand
whether the rotors with knives turn without jamming.
16. In the event of shearing the bolts in the PTO shaft (if this type of shaft is installed), protecting the machine
against damage, replace only bolts recommended by the factory, i.e. M8 x 60-8.8 B bolt acc. PN-85/M-
82101. The bolt strength 8.8 is stamped on the bolt head.
17. Do not adjust the bolts of the overload clutch in the articulated telescopic shaft (if this type of shaft is
installed).
When starting work, switch on PTO revolutions in transport position and after reaching 540 rpm
smoothly lower the unit while driving forward.
Caution: It is not allowed to start work with the unit knives submerged in the ground.
It is not allowed to operate the unit while driving backwards.
4.
Daily Maintenance
Observe the safety instructions for daily maintenance. Your machine has been designed and built to
achieve maximum efficiency, profitability and comfort in a variety of working conditions. Your machine has been
inspected at the factory and by our distributor before delivery, to ensure that you receive the machine in
excellent condition. In order to keep the machine in perfect working condition, perform the daily maintenance
at the indicated intervals.
In order to keep the machine in good condition and achieve optimum performance at all time, it is
necessary to clean and perform the maintenance work on the machine at regular intervals. Hydraulic, electric
assemblies and bearings may not be washed with a high-pressure cleaner, or with direct water jets. Gears, bolted
joints and bearings are not sealed id washed with water under VERY high pressure.
4.1.
Maintenance Intervals
Maintenance intervals are determined by a number of factors. They are affected, for example, by different
working conditions, weather conditions, driving and operating speeds, formation of dust, soil type, etc., the
quality of the lubricants and preservatives used, which determine the length of time to carry out the next
maintenance work.
The indicated review intervals can therefore only serve as reference points. When we go away of the normal
conditions of use, the periods between maintenance works must be adapted to these conditions:
1/ After the first 10 hours of operation:
- Check tightness of all bolts and nuts.
- Check the hydraulic system (for tightness).
- Check the tightness of the wheel nuts.
- Carry out complete machine diagnostics to ensure there is no problem.
- Clean the machine from the soil.
2/ After the first 50 hours of operation
- Check tightness of all bolts and nuts.
- Check the hydraulic system (for tightness).
- Check the tightness of the wheel nuts.
- Carry out complete machine diagnostics to ensure there is no problem.
- Lubricate the articulated joints provided with the grease nipples.
FENIX G Operating manual
- page 28 -
Advertisement
Table of Contents
