Table of Contents
Advertisement
When the machine is at work, never come close to the area of effect of the bout markers
3.6.
The depth of the cultivation.
For operation, the unit must be set perpendicularly to the ground. Before commencing adjustment, the unit
must be mounted on the tractor and lowered to the working position on a flat and hard surface.
Two adjustment knobs on both sides of the machine are used to adjust the working depth of the unit (Fig. 18).
By turning them clockwise, the working depth decreases. Turning them counterclockwise increases the working
depth.
Note: The set length of both adjustment knobs should be the same.
3.7.
Work with the unit and operating conditions.
Obtaining the correct effects of the unit operation requires fulfilling the following rules:
1.
Check that the machine is correctly attached to the tractor.
2.
Read this OPERATING MANUAL carefully.
3.
Before entering the field, check the condition of threaded connections and the condition of working
elements.
4.
Check and correct the working depth if necessary.
5.
Maintain an even driving speed.
6.
Always clean the machine after finishing work.
7.
Replace damaged parts immediately with new original ones.
8.
At the headlands, raise the unit to a height that allows to perform a manoeuvre without catching the ground
with working elements.
9.
During the subsequent working passes, the unit should be driven in a straight line, without leaving any
bypasses. When working with the seed drill, follow the tracks made by the marker of the seed drill.
10. Violent jerks should be avoided.
11. Remedy any defects as soon as they are discovered.
12. Avoid working on stony soils.
13. Use the correct lubricants and adhere to the lubrication schedule according to the lubrication chart.
14. Check the tightening of bolts and nuts every 30 hours of operation. The tightening torque of the knife
mounting bolts - 350 Nm.
FENIX G Operating manual
Adjustment knobs
Fig. 18
- page 27 -
Advertisement
Table of Contents
