Preparation For The First Start-Up - UNIA FENIX G Operating Manual

IX. PREPARATION FOR THE FIRST START-UP
Follow the steps listed in the chapter before the first start-up of the unit:
When preparing the machine for operation, connect it to the tractor first.
There is a risk of injury when connecting and disconnecting to/from the tractor! Do not stand between the
tractor and the machine or behind the machine during connecting and when the machine is not secured
against rolling away with securing wedges or with the parking brake.
At the moment of start-up it is prohibited to stay within the machine's reach.
Connecting the seed drill to the tractor
1-Machine drawbar/suspension axle, 2-pin, 3-tractor's links, 4-central bolt.
a) Connect the unit with the tractor.
To do this, connect the holder/suspension axle [1] with the tractor links [2] by means of the bolt [3] and
install the central bolt of the tractor [4]. Remember to secure the pins against sliding out.
b) Connect the hydraulic system hoses with the quick couplers of the external circuit of the tractor
FENIX G Operating manual
Fig. 1 Retracting the drive wheel
1-drive wheel, 2-securing cotter pins
Fig. 2 Connecting the seed drill to the tractor.
- page 12 -