tayco Halifax Installation Manual page 29

Integration Box Height Adjustable Table (HAT)
Place the surface face down
7.
on a clean solid surface or
floor.
Install HAT skirt to the
8.
surface, please see how to
install HAT skirt.
Prepare and install the HAT
9.
table mechanism to the
surface. Use HAT table install
instructions which comes in
the HAT mechanism box.
Note: prior to joining other
storage unit.
Depending on the desk
10.
configuration left or right.
Install leg mounting plate
depending the configuration
LH and RH using 3/8-16 x 2"
Flat Head Screws, Square
Drive, (LH shown, Figure 6).
Note: 4 of the 8 holes used
depending on LH or RH.
Indicate which holes for LH
and which holes are for RH.
Install the E-chain carrier
11.
assembly bracket to the
surface. Use 2 each #8 x 5/8"
Flat Head Screws, (Figure 7).
Continued on the next page >>
SURFACE
7
HAT LEG
8
HAT LEG MOUNTING PLATE
9
3/8-16 X 3/4" FLAT HEAD HEX SCREW
1 0
E-CHAIN CARRIER ASSEMBLY BRACKET
1 1
#8 X 5/8", FLAT HEAD SCREW, QUADREX
1 2
HAT SKIRT
2 0
January 2021
Drill Robertson # 2
10
8
RH TABLE CONFIGURATION SHOWN
11
2 0
8540-1347
Phillips Bit 3/8-16 x 3/4", Flat
Head Hex Screw
Halifax
9
2 0
12
1 1
7
Tools & Hardware Needed
8540-0605
#10 x 5/8", Flat
Head Screw
Figure 6
1 2
Figure 7
Page 26