Entering Standby Mode - Siemens RAPIDLAB 248 Operator's Manual

Page 2-14

Entering Standby Mode

This routine conserves reagents. During Standby the sensors are kept
wet and the pump tubes moved from time to time to keep them in good
condition. The 248 does not calibrate while in standby mode, but
automatically calibrates as required when restarted, before allowing
sample measurements.
1. From Ready press # for menu and 7 for Standby.
2. You can restart the 248 from standby mode in two ways:
Setting Auto Restart Time
1. To set the auto restart time press #.
2. Enter the time required and press * to Exit. If the time displayed is
Standby
Press * to restart now
#
press to set auto restart time
a. press * to restart the 248 immediately, or
b. set an auto restart time. If a time is set, the 248 automatically
restarts at that time.
Set Auto Restart Time
press * to Exit
the time you want for auto restart, just press *.
Standby
Auto restart at 08:30
press * to restart now
#
press to cancel auto restart
Auto restart at
08:30
248 Operator's Manual
11:03:48
11:03:55
11:04:10