Table of Contents
Advertisement
s
Use ▲▼ to select the configuration layer for the parameter you
2.
wish to set.
Press MODE to confirm. Press ▲▼ to select the particular pa-
3.
rameter.
Press MODE to confirm. Press ▲▼ to adjust the parameter val-
4.
ue.
Press MODE again to end. Press ▲▼ to select
5.
6.
Now use MODE to either apply the changes you have made to the
SAVE
settings [
END
[
] . After that, the display panel will resume showing the
temperature reading.
Parameter
EPS.Q
AO1._
AO1.~
AO1.4
AO1.T
NOTE !
Key lock may have been activated at the terminal. When selecting
the configuration layer you will be prompted to enter an access
code with
P100
enter
but not change them.
6.7
Setting Emissivity (Spectral mode)
A pyrometer measures temperature by detecting the radiant energy emit-
ted from an object's surface in the form of electromagnetic waves. The
temperature reading not only depends on the intensity of the object's
thermal radiation (how hot the object is), but also on the material's par-
ticular surface characteristics and thus its specific ability to emit thermal
energy. This is called emissivity. To obtain an accurate temperature
] or to close without saving these changes
configuration
layer
C001
C010
C010
C010
C100
P000
. To obtain full access to parameter settings,
otherwise you will only be able to view parameters
Operating manual PA
Explanation
Ratio correction
(see chapter 6.8)
Lower limit of temperature span
analogue output Ao1
(see chapter 6.10)
Upper limit of temperature span
analogue output Ao1
(see chapter 6.10)
Hardware configuration of the ana-
logue output 0-20 mA, 4-20 mA
(see chapter 6.10)
Temperature measurement simula-
tion to verify signal transmission
(see chapter 6.11).
17
END/SAVE.
Advertisement
Table of Contents
