Configuring Otoread™ Module To Work With Otoaccess ® 2.X Or Higher - Interacoustics OtoRead Instructions For Use Manual

14. Select Serial under Device Communication. This applies even if the OtoRead
USB-to-serial cable
connected using a
defined in OtoAccess
®
Now OtoAccess and the OtoRead™ Module are ready to retrieve data from the OtoRead™.
2.8 Configuring OtoRead™ Module to work with OtoAccess
1. Following installation, the OtoRead™ Module software will automatically appear on the module bar in
OtoAccess 2.x. It is displayed as OtoRead Legacy.
®
NOTE:
OtoAccess 2.x uses serial port COM1 as a default for the communication between the OtoRead™
®
device and OtoRead™ Module. The serial port must be set to COM1 in the PC's Device Manager for a
connection to be established.
Refer to section 4 (Troubleshooting & FAQs) for further information about finding or changing the COM
port settings on your PC.
2. Start the OtoRead™ Module by clicking on the OtoRead Legacy icon.
D-0115350-B – 2019/04
OtoRead™ Module - Instructions for Use - EN
. The Serial Port will display the Serial (com) port that was
®
earlier. If USB was selected, the value will be 0. Press OK.
device is
TM
® 2.x or higher
Page 5