Table of Contents
Advertisement
ATTO Technology, Inc.
ATTO FibreBridge Maintenance Menu
FibreBridge Maintenance Menu
A
LIP Fibre Channel Port
B
Display FibreBridge Version Information
C
Restart FibreBridge Firmware
D
Reset SCSI Port 1
E
Reset SCSI Port 2
X
Return to previous menu...
ATTO FibreBridge Diagnostic Menu
FibreBridge Diagnostic Menu
A
Display Error Log
B
Clear Error Log
C
Identify FibreBridge
X
Return to previous menu...
Save / Restore Configuration Menu
Save / Restore Configuration Menu
A
Save Configuration Changes
B
Restore Configuration to Default
C
Restore Configuration to Last Saved
X
Return to previous menu...
Fibre Channel Configuration Menu
Fibre Channel Configuration Menu
A
FC-AL Hard Addressing Mode
B
FC-AL Hard Address
C
FC-AL Arbitration Fairness
D
Unprocessed SCSI Command Returns
E
Fibre Channel Frame Length
F
Physical Device Address Descriptor
G
Logical Unit Address Descriptor
H
Virtual Device Address Descriptor
I
FC-AL Address Translation
J
FibreBridge Soft SCSI ID Status
K
FibreBridge SCSI ID
Full Duplex Mode (FibreBridge 2200R/D and
L
3200R)
M Port Connection Mode (FibreBridge 2200R/D and
3200R)
Notes
Force LIP on Fibre Channel port
Display the initial status screen
Cause the unit to reload the firmware and restart
the ATTO FibreBridge
Force reset on SCSI port 1
Force reset on SCSI port 2
Return to the ATTO FibreBridge main menu
Notes
Display the current error log entries. Entries in the
log do not necessarily mean that the unit is
damaged or inoperable
Clears the current error log
Identifies the ATTO FibreBridge in use
Return to the ATTO FibreBridge main menu
Notes
Restart/No Restart Prompt
Confirmation Prompt
Confirmation Prompt
Return to the FibreBridge Main Menu
Notes
Display, Enable or Disable FC-AL hard Addressing
Display or set the FC-AL hard address is Hard
Address mode is enabled
Display, Enable or Disable Arbitration Fairness
Provides options for configuring SCSI port
1BUSY/QUEUE FULL response
Display or set the Fibre Channel frame length
Display or set the PDAM descriptor
Display or set the LUAM descriptor
Display or set the VDAM descriptor
Display, Enable or Disable FC to SCSI Address
Translation
Display, Enable or Disable weather the hardware
or software SCSI ID is used for the ATTO
FibreBridge unit
Display or set the soft SCSI ID of the ATTO
FibreBridge unit. This is the target ID to which the
ATTO FibreBridge itself will respond to SCSI
commands sent to the ATTO FibreBridge itself
rather than to SCSI devices attached to it
Display, Enabled or Disable Full Duplex
Display Prompt for connection mode
ATTO Technology, Inc.
22
-
-
ATTO FibreBridge Software Manual
Advertisement
Table of Contents
