Fibre Channel Configuration Menu Cont.'d; Scsi Port Configuration Menu; Serial Port Configuration Menu - ATTO Technology FibreBridge 2100R Software Manual

ATTO Technology, Inc.

Fibre Channel Configuration Menu cont.'d

N Class 2 Service Parameters (FibreBridge 2200R/D
and 3200R)
O Use ACK0 for Class 2 Service (FibreBridge
2200R/D and 3200R)
P Fibre Channel Initiator Mode
X Return to previous menu...

SCSI Port Configuration Menu

SCSI Port x Configuration Menu
A Initiator ID from Hardware Switch
B SCSI Initiator ID
C Reset SCSI Bus on Startup
D Tagged Command Queuing
E Wide SCSI Transfers
F Synchronous SCSI Transfers
G SCSI Bus Speed
H Selection Timeout
X Return to previous menu...

Serial Port Configuration Menu

Serial Port Configuration Menu
A Baud Rate
B Flow Control (Handshaking)
C Stop Bits
X Return to previous menu...
Display, Enable or Disabled Class 2 Service
Parameters
Display, Enabled or Disabled ACKO for Class 2
Service
Enable / Disable Initiator Mode
->FibreBridge Configuration Menu
Notes
Display, Enable or Disable use of the hardware
SCSI initiator ID for the SCSI bus. Note, this
differs from the ATTO FibreBridge SCSI ID option
which sets the use of a soft or hardware ID of the
ATTO FibreBridge itself
Display or set the SCSI initiator ID of the SCSI bus
Display, Enable or Disable weather the SCSI bus
resets on startup of the unit
Display, Enable or Disable use of Tagged
Command Queuing
Display, Enable or Disable forced (as opposed to
negotiated) Wide SCSI transfers
Display, Enable or Disable Synchronous SCSI
transfers
Displays the transfer rate at which the FibreBridge
will attempt to negotiate with its SCSI devices.
Display or set the selection timeout for the SCSI
bus
Return to the ATTO FibreBridge configuration
menu
Notes
Display or set the baud rate for the RS-232 port.
The baud rate may be set to 2400, 9600, 19200,
38400, 57600 or 115200 baud
Display or set the current handshaking mode. The
handshaking mode may be set to hard (hardware),
xon (Xon/ Xoff) or none
Display or set the number of bits. The ATTO
FibreBridge supports 1 or 2 stop bits
Return to the ATTO FibreBridge configuration
menu
ATTO Technology, Inc.
23
- -
ATTO FibreBridge Software Manual