Draining The Internal Water - Interacoustics Aqua Stim Instructions For Use Manual

Aqua Stim Water Irrigator Instructions for Use - EN

3.7 Draining the Internal Water

The Aqua Stim holds 300 ml of water internally. Some water will remain inside the irrigator and its tubes
after irrigations. This water must be drained prior to shipment of the irrigator.
Draining the internal water using handle
1. Aqua Stim allows you to drain the internal water using the irrigation handle. When the irrigator is in
standby mode press the Time Up/Down buttons simultaneously. This will put the irrigator in Drain mode.
Use Handle Drain
2. Point the handle into an empty bucket (with at least 500ml capacity) and click the handle button to initiate
a flush of the internal tank.
Draining...
3. At the end of the drain cycle, power off the irrigator.
Drain Complete
Turn Off Power
4. Disconnect all the tubes (red, blue, grey and white), the handle electrical connector and the USB cable.
Some water will come out of the handle tubes. Some water will come out of the Red / Grey outlet
connector. Please have a towel handy to clean up drips. Set the handle assembly aside and drain
manually.
If you need to perform the draining procedure manually, use the following steps:
Manual draining procedure
1. Disconnect the handle tubes (red and blue) and its electrical connector. Some water will come out of the
handle tubes. Some water will come out of the Red outlet connector. Please have a towel handy to
clean up drips. Set the handle assembly aside.
2. Disconnect the tube with white label from "Inlet" connector on the back panel and the inlet connector on
the water tank.
3. Move the tube with grey label from the "Outlet" connector to the "Red" connector on the back panel. Do
not disconnect this tube from the external tank.
4. Power on the irrigator and press the "Cool" button. The display will read "Filling" and water from within
the irrigator will be purged out to the external tank.
5. When the irrigator gives the "No Water in Tank" message, turn off the irrigator.
6. Drain water from the handle assembly by allowing gravity to drain the water out.
The Aqua Stim should now be drained of water and ready for shipping. Drain the external tank, disconnect
remaining tubes / cables and pack the irrigator components with proper packing material in the provided
shipping container.
40s
To remove the tubes you will need to push on the small ring next to the tube
using two finger tips while pulling gently on the tube.
Page 16