Sony HDCU3500 Service Manual page 106

Item
PGM SOURCE
MEDIA CLOCK
DIRECT
AUDIO
HD TRUNK AU-
DIO
INTERCOM
TEST OUT
TEMPERATURE
Screen display
<TEMPERATURE>
VIF FRONT : 27.0
VIF FPGA(ON BOARD) : 33.0
VIF FPGA(INTERNAL) : 39.0
NET FPGA(INTERNAL) : 42.0
POWER UNIT : 28.0
FRONT PANEL : 25.0
TX1 FPGA(INTERNAL) : 43.0
TX2 FPGA(INTERNAL) : 45.0
ENC FPGA(INTERNAL) : 84.1
Screen display
Item
VIF FRONT
VIF FPGA (ON BOARD)
VIF FPGA (INTERNAL
HDCU3500/HDCU5500
Setting Value Description
D-SUB&IP, D- Set the signal input source used as a PGM.
SUB, IP D-SUB&IP: Both D-SUB connector input and IP stream input
are used.
D-SUB: Only D-SUB connector input is used.
IP: Only IP stream input is used.
D-SUB&IP and IP are selectable only when the NET board is
mounted and IP Intercom stream is received. When the NET
board is not mounted, D-SUB is fixed.
Set the Media Clock Direct value to be sent using the SAP pro-
－
tocol for each IP Audio stream. When a long-distance system is
built, a network transmission delay is generated. Therefore,
streams may be discarded due to delay restrictions depending on
receivers of other vendors. (Example: 2 ms or less delay in the
AES67 mode of Dante)
To avoid this problem, adjust this setting value according to the
transmission delay time.
-682.666 to Set the Media Clock Direct value of the IP Audio stream.
682.645 [ms],
0.000
-682.666 to Set the Media Clock Direct value of the IP HD Trunk Audio
682.645 [ms], stream.
0.000
-682.666 to Set the Media Clock Direct value of the IP Intercom stream.
682.645 [ms],
0.000
OFF, IP RETURN Used to output the IP RETURN signal from the SDI connector
for test. This is a simple check function used when the ST2110
system has been built. This function is reset by turning off and
on to prevent incorrect operation.
IP RETURN stream and output connector are in the following
relationship.
IP RET1 → SDI OUT1
IP RET2 → SDI OUT2
IP RET3 → SDI OUT3
IP RET4 → SDI IO1 (A down-converted (4K to HD) signal is
output.)
?S08 TOP
With HKCU-SFP50 installed
With HKCU-FB50 installed
With HKCU-REC55 installed
Setting Value Description
－ Display the temperature of VIF-75 board.
Continued
4-8