Table of Contents
Advertisement
24
000000-1520-928_GA_EN_021013
Installation
• Confirm your selection by clicking on OK. The Confirm Desktop
Change dialog appears.
• Confirm with OK.
Alternatively you can proceed as follows:
• Click on the symbol on the right side of the task bar.
• Select Graphics Properties... from the menu bar.
®
• Select "Intel
Dual Display Clone" and then "Notebook + Monitor" in the
Output To field.
• Double-click on the Save Configurations program icon on the Microsoft
Windows desktop to save the new configuration. The device will restart.
Always switch on the external monitor before switching on the
® plus
i.Profiler
booting the device.
Integrating the i.Profiler
via DHCP
• Connect the i.Profiler
cable.
• After the start, quit the i.Profiler
Application button in the Shut Down window and switch to the
Microsoft Windows desktop (administrator rights required).
• Double-click the Network Configurator symbol on the desktop. The
Network Configuration Tool dialog appears.
• Select the Ethernet connection used by your network in the Network
Adapter field. The left connection is marked [00000000], the right
connection [00000001].
• Select Activate DHCP.
• Click on the Change IP button. The message "Change to DHCP was
successful" appears.
• Close the Network Configurator.
• Double-click on the Save Configurations program icon on the Microsoft
Windows desktop to save the new configuration. The device will restart.
otherwise the monitor will not be registered when
® plus
into an existing network
® plus
to the practice network (LAN) using a network
® plus
software by pressing the Close
Advertisement
Table of Contents
