Table of Contents
Advertisement
34
000000-1520-928_GA_EN_021013
Installation
Installation of the Atlas Review Software connection
The Atlas Review Software is optionally available and will not be
offered in all countries.
To install the Atlas Review Software on a PC follow the user manual Atlas
Corneal Topography System Review Software until chapter Connecting the
Review Station to an ATLAS Instrument.
Please contact Carl Zeiss Meditec, Inc. if you need installation support.
Connecting the PC with the Atlas Review Software directly to
® plus
the i.Profiler
(peer to peer)
• Connect the PC to the i.Profiler
non-crossover cable with a crossover adapter.
Observe the safety precautions and requirements regarding cable
type and length.
• Switch on the PC.
• Configure the PC with the aid of the user manual provided with the
device as follows:
IP address:
Subnet mask:
Standard gateway: 0.0.0.0
• Generate a local directory on the PC.
• Create a user account on the PC under the name "iProfiler" and using the
password "iProf08_CZM".
• Release the local directory on the PC with reading and writing rights for
the user account previously created.
• Switch the i.Profiler
software by pressing the Close Application button in the Shut Down
window+ and switch to the Microsoft Windows desktop (administrator
rights required). The LAN connection may be indicated in the task bar
bottom right when the PC is connected. Ignore this message for the time
being.
® plus
using a so-called crossover cable or a
192.168.103.101, when using the right network
connection or 192.168.100.101 when using the left
network connection of the i.Profiler
see page 22 (1, Fig. 9).
255.255.255.0
® plus
on. After the start, quit the i.Profiler plus
® plus
,
Advertisement
Table of Contents
