Advertisement
this process, the self-cleaning symbol will be illuminated, and the display window
will indicate the remaining time.
6.
After 20 minutes of one self-cleaning program completing, pull out the drainpipe of
the water tank and drain the cleaning solution down to the lower ice storage bin.
Shake the unit slightly to drain out all the cleaning solutions completely. Reinstall
the drainpipe to the slot of the water tank.
7.
Repeat steps 4-6 to clean the ice making assembly system again.
WARNING:
•
Ice machine cleaning products contains acids.
•
Do not use or mix with any other solvent-based cleaner products.
•
Use rubber gloves to protect hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
8.
Open the tap of the main water supply and allow the water to flow in the unit. Press
and hold the "Timer/Clean" button on the control panel for more than 5 seconds to
enter the self-leaning program.
9.
As above, the water pump runs for 8 minutes and stops for 3 minutes, then runs
another cycle. The total duration time is 20 minutes for one self-cleaning program.
During this process, the self-cleaning symbol will be illuminated, and the display
window will indicate the remaining time. Through this process, it will rinse the water
dividing pipe, evaporator, water pump, silicone pipe and water tank, etc.
10. After the self-cleaning program is complete, pull out the drainpipe of the water
tank, drain the cleaning solution down to the lower ice storage bin and shake the
unit slightly to drain out all the water completely. Reinstall the drainpipe to the
water tank slot tightly.
11.
Repeat steps 8-9 another two times.
12. Following the above directions to clean the ice storage bin.
13. Once this process has been completed, the machine can return to regular ice
making. It is suggested to discard the first batch of ice cubes made after cleaning.
Advertisement
