Advertisement
3.
Connect the water hose to the water supply
Install the supplied quick-connector (from ¼" to ½" with a black sealing ring) to the water
tap by screw thread. Remove the clipper from the quick-connector and insert the free
end of the water hose into the quick-connector port completely. Reinstall the clipper to
lock the water supply hose into place.
Important: The water pressure of the main water supply system must be 0.04-05 MPa
at least, and 0.6 MPa at most. If the pressure is too high, a pressure decreasing valve
should be installed.
Step 1: Quick-
connector and
water tap
Step 2: Screw the
quick-connector onto
the water tap and
remove the clipper
Step 3: Insert the
water hose into the
quick-connector
completely
Step 4: Reinstall
the clipper
Advertisement
