Sony ICP-X7000 Installation Manual page 109

5. Tighten the length adjustment screws (B4 x 6, two
screws for each bracket) which are loosened in step 3.
6. Align the bent section of the each rack bracket on the
side panels of the unit to the rail, and then slide the unit
backward.
t
Each rack bracket covers the rails as shown in the
figure below.
Rack bracket
Rail
n
When the unit is pulled out about 270 mm, the rack brack-
ets are disengaged from the rails.
When you pull out the unit, support the bottom of the unit
firmly so that you do not drop it.
7. Secure the rack angles to the rack with the specified
four screws (B5 x 12).
n
Use the screws (B5 x 12) supplied with the unit.
B5 12
ICP-X7000
Rack bracket
Rail
B5 12
t
If you have trouble engaging the rack bracket with the
rail or trouble attaching the front panel to the unit,
adjust the position of positioning plate.
Positioning plate
5. Installing the Front Panel
Attach the front panel to the main unit, and tighten the two
anti-drop screws.
Anti-drop
screw
Front panel
Anti-drop screw
2-13 (E)