Cleaning The Lint Screen - Asko TL751 XXL Operating Instructions Manual

User-maintenance instructions

Cleaning the lint screen

1. Clean the lint filter once either before
or after drying each load. Always make
sure the lint filter is clean before starting
a new load, because a clogged lint filter
may increase drying times.
2. To clean, pull the lint screen straight up
and roll any lint off the screen with your
fingers. Push the lint screen firmly back
into place.
3. Always ensure the lint screen is firmly
secured before running the dryer.
Running the dryer with a loose lint
screen may cause overheating and
damage to the dryer and articles being
dried.
4. Some articles may shed more lint than
others, causing the lint screen to fill
rapidly. Remove lint from the lint screen
before and after drying these articles,
such as new towels.
5. In the event lint falls off of the lint screen
and into the dryer during removal,
inspect the exhaust hood and remove
any lint.
6. Laundry detergent and fabric softener
residue can build up on the lint screen,
causing longer drying times. The
screen is likely blocked if lint falls off
the screen. In order to prevent this type
of build up, and help ensure proper
operation of your dryer, clean the lint
screen with a nylon brush every six
months or more frequently, if necessary.
The lint filter can also be washed as
follows:
a.) After rolling the lint off of the screen
with your fingers, wet both sides of
the screen with hot or warm water.
b.) Wet a nylon brush with hot water
and liquid detergent and scrub the
lint screen with the brush to remove
the buildup of detergent and fabric
softener.
42
c.) After the residue has been removed,
rinse screen with hot water.
d.) After drying the lint screen with a
clean towel, firmly replace the lint
screen in your dryer.
Customer Care Center
1-800-898-1879
www.askousa.com