Table of Contents
Advertisement
Care and maintenance instructions
Cleaning the lint filter
The lint filter must be cleaned after each load.
1. Lift the filter from the holder in the door.
2. Open the lint filter. Use your thumb to press
on the edge as illustrated and pull it out.
14
3. Use your hand or a soft cloth to remove the
lint from all sides of the filter. If necessary,
use a damp sponge and a small amount of
washing-up liquid dish soap to remove any
deposits. Dry the filter thoroughly with a
towel.
NOTE!
Clean the surface of the lint (fluff) filter after
each drying program.
4. Close the lint filter and put it back in the door.
Close the lint filter before closing the door.
NOTE!
The dryer should never be operated without
the filters in place, or with damaged filters as
excessive amount of accumulated fibres from
the fabric could cause malfunction or failure of
the dryer.
NOTE!
Clean the filters after each drying.
Do not replace the filters if they are damp or
wet. Damp or wet filters could cause operational
faults.
Customer Care Center
1-800-898-1879
www.askona.com
Advertisement
Table of Contents
