Quick Reference - ETC ColorSource CYC v1.7 Installation Manual

ETC Installation Guide
ColorSource CYC v1.7

Quick Reference

DMX Control Channels
5ch
DMX
Channel (5 channel)
1 Intensity
2 Red
3 Green
4 Blue
5 Strobe*
6
7
*Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
Error Codes
There are three error codes that may be shown on the user interface.
CAL
•
the color calibration. The fixture will need to be returned to the ETC
factory; contact your local dealer to set up a repair.
OtP
•
has gone into over-temperature protection mode to avoid damaging
the fixture. Once the fixture has self-cooled, the error will automatically
clear.
No App
•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
ColorSource CYC
dir
(Direct)
Intensity
Red
Green
Blue
Indigo
Lime
Strobe*
: Screen toggles between
: Screen toggles between
: Screen toggles between
1ch
(1 Channel)
Intensity
CAL ERR
and to indicate a problem with
OtP ERR
and to indicate that the fixture
no APP
and
Page 12 of 12
rgb
(RGB)
Red
Green
Blue
to indicate that the
ETC