Quick Reference - ETC ColorSource Linear Installation Manual

ETC Installation Guide
ColorSource Linear v1.7

Quick Reference

DMX Control Channels
Linear 1 and Linear 2/Linear 4 in Group Mode
5ch
DMX
Channel (5 channel)
1 Intensity
2 Red
3 Green
4 Blue
5 Strobe**
6
*Original ColorSource Linear fixture uses blue in channel 4; Deep Blue fixture uses indigo in
channel 4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
Error Codes
There are three error codes that may be shown on the user interface.
CAL
•
the color calibration. The fixture will need to be returned to the ETC
factory; contact your local dealer to set up a repair.
OtP
•
has gone into over-temperature protection mode to avoid damaging
the fixture. Once the fixture has self-cooled, the error will automatically
clear.
CBL
•
card or the internal cabling is damaged or unplugged. Verify that
internal cables are properly connected. If the error persists, the fixture
will need to be returned to the ETC factory; contact your local dealer to
set up a repair.
No App
•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
ColorSource Linear
dir
(Direct)
Intensity
Red
Green
Blue/Indigo*
Lime
Strobe**
: Screen toggles between
: Screen toggles between
: Screen toggles between
: Screen toggles between
1ch
(1 Channel)
Intensity
CAL ERR
and to indicate a problem with
OtP ERR
and to indicate that the fixture
CBL ERR
and to indicate that a control
no APP
and
Page 20 of 20
rgb
(RGB)
Red
Green
Blue
to indicate that the
ETC