Set The Dmx Address - ETC ColorSource CYC v1.7 Installation Manual

ETC Installation Guide
ColorSource CYC v1.7
Adjust the Tilt
When pipe-mounting the fixture, tilt the fixture so that the base of the fixture
is perpendicular to the cyclorama.
1. Loosen, but do not remove the yoke locking knobs.
2. Tilt the fixture so that the base of the fixture is perpendicular to the
cyclorama.
3. Tighten the yoke locking knobs.
Adjust the Spill
Control
Adjust the angle of the spill
control as needed.
Set the DMX Address
1. Press any button to wake
the display. The display
shows the DMX address.
2. Use the Up and Down buttons to select the DMX address for the
fixture.
You can also use RDM for DMX addressing. See
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows the
current DMX control mode.
3. Press the Up button or Down button to change the DMX control
mode:
•
•
•
•
4. Press the Mode button to confirm your selection.
ColorSource CYC
5ch
: 5-channel mode (intensity, red, green, blue, and strobe). This
is the default mode.
dir
: Direct emitter control (intensity, red, green, blue, indigo,
lime, and strobe).
1ch
: 1-channel mode controls the intensity of preset 1 (defaults
to 3200 K White).
rgb
: RGB mode (red, green, and blue).
Spill
control
RDM Values on page 10
Page 5 of 12
.
ETC