ETC ColorSource CYC v1.7 Installation Manual page 8

ETC Installation Guide
ColorSource CYC v1.7
Pre-configured Sequences
Sequence Name
1
2
3
4
5
Re-record Presets
1. Using DMX, set the desired levels for the new preset.
2. Press the Mode button to access the Presets/Sequences menu.
3. Press the Up button or Down button to navigate to the preset number
that you want to re-record.
4. Press and hold the Mode button for 3 seconds to confirm the preset
selection. The user interface will show a 3-second countdown. The
preset number blinks once to confirm that the preset has been
recorded.
Note:
1ch
( ), you cannot re-record presets.
When you re-record presets with the fixture in RGB mode (
intensity is set to full and the strobe is turned off.
See Change the DMX Control Mode on
Adjust the Intensity of Presets
1. Ensure that DMX data is not present.
2. Press the Mode button to access the Presets/Sequences menu, and
then press the Up button or Down button to select the preset that you
want to edit.
3. Press and hold the Mode button for 3 seconds. The display shows
followed by either an intensity level from
4. Press the Up button or Down button to change the intensity level of
the preset in real time.
5. Press the Mode button to confirm your selection and return to the
Presets/Sequences menu.
The display will automatically return to the Presets/Sequences menu after 10
seconds of inactivity, and edits to the preset intensity will not be saved.
ColorSource CYC
Rainbow Fast
Rainbow Slow
Warm Colors Fast
Cool Colors Fast
Random
When the fixture is in Direct mode (
dir
) or 1-channel mode
page 5.
0– 99
Page 8 of 12
rgb
), the
FL
or for full.
L:
ETC