Error Codes; Rdm Values - ETC ColorSource CYC v1.7 Installation Manual

ETC Installation Guide
ColorSource CYC v1.7

Error Codes

There are three error codes that may be shown on the user interface.
CAL
•
the color calibration. The fixture will need to be returned to the ETC
factory; contact your local dealer to set up a repair.
OtP
•
has gone into over-temperature protection mode to avoid damaging
the fixture. Once the fixture has self-cooled, the error will automatically
clear.
No App
•
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.

RDM Values

Parameter
Manufacturer ID
Model ID
DMX Start Address
DMX Personality
Output Frequency
ColorSource CYC
: Screen toggles between
: Screen toggles between
: Screen toggles between
Value
0x6574
0x0215
0x00F0
0x00E0
0x8123
CAL ERR
and to indicate a problem with
OtP ERR
and to indicate that the fixture
no APP
and
Description
Electronic Theatre Controls
ColorSource CYC
Range = 1–512
1 = 5 Channel
2 = Direct
3 = 1 Channel
4 = RGB
0 = Standard (1.2 kHz)
1 = High (25 kHz)
Page 10 of 12
to indicate that the
ETC