Configuring The Data Logger; General Settings - Magna BLUEPIRAT Series Camera User Manual

BLUEPIRAT SERIES | CAMERA USER GUIDE/
page 76 of 93

14 Configuring the data logger

14.1

General settings

The logger should be configured as DHCP server, if it is not already configured accordingly (de-
fault value).
Therefore click on the application [Open configuration] (5) in the System Client. Expand the
folder [General] in the window to the right and click on [Network settings]. Enable the <DHCP
mode> (o) DHCP server or (o) Automatic DHCP Configuration for TSL.
Figure 14.1: Selecting an application in the System Client
Figure 14.2: Setting the network settings in the System Client
Please be sure about the setting of the logger's standby.
You can activate or deactivate the automatic standby at [General]  [Standby]. If active, there
are two different time settings for network connection.
If the data logger is not connected to a network at the front Ethernet port and does not receive
any data during the timeout entered in the upper text field, then it shuts down and enters
standby mode.
If the data logger is connected to a network at the front Ethernet port with active link and does
not receive any data during the timeout entered in the lower text field, then it shuts down and
enters standby mode.