Table of Contents
Advertisement
8 Configuring the network camera AXIS 207/210/211
Warning:
The camera must have installed the firmware version 4.40. If there is another firmware
version installed it is recommended to install the 4.40.
Any camera that is used with the data loggers BLUEPIRAT2 / BLUEPIRAT2 5E / BLUEPIRAT
Mini can be installed manually or automatically (recommended).
The manual configuration is done over the camera web interface.
The automatic configuration is done with the program "AXIS Camera Management". For this
variant a template is available.
8.1
Related manuals
AXIS 207 User Manual [1]
AXIS 210 User Manual [2]
AXIS 211 User Manual [3]
8.2
Automatic configuration (recommended)
Needed software: AXIS Camera Management v2.00.31
http://www.axis.com/techsup/software/index.htm
http://www.axis.com/de/products/cam_mgmt_software/interface.htm
Configuration steps:
9. Check firmware version. Recommended: 4.40 (more information see [1], [2], [3] or AXIS
online).
10. Resetting camera to the factory default settings (more information see [1], [2] or [3]
chapter "Resetting to the Factory Default Settings").
11. Connect the camera with the PC / laptop via an Ethernet cable.
12. Set the password (more information see [1], [2] or [3] chapter "Set the password").
13. Install camera template by using the program "AXIS Camera Management".
14. Add administrator.
BLUEPIRAT SERIES | CAMERA USER GUIDE/
or
page 44 of 93
Index
Advertisement
Table of Contents
